fitting a cat flap to a glass door!

[LadyJane]

There is 1 window at the back but I think it would be too high for him... he can jump down but jumping up isn't a strong point.  Also not sure that the ledge would be sufficient enough.  Will take another look next time we're there though.

Thanks xxx

[Gillian Harvey]

Hi everyone, it's been a long time since I've been on here as life has been pretty manic for a while but a big HELLO to anyone who remembers me!

 We were wondering instead whether it's possible to replace one of the side panels (maybe half the width of a normal door) with a solid UPVC panel in order that we can make a hole in it to accommodate the flap.

Hi, yes I remember you, nice to see you back  I did something similar when I had new UPVC windows fitted at my old house. It wasnt in french doors, but in an ordinary window, so half the window was soldi UPVC witht he cat flap in it.

[Tiggy's Mum]

  back LJ 

I'm not sure about the solution with the french doors but is there a rear ground floor window you could fit a flap into? Would be much cheaper than the patio option as the pane of glass would obviously be smaller.

[LadyJane]

Hi everyone, it's been a long time since I've been on here as life has been pretty manic for a while but a big HELLO to anyone who remembers me!

I was hoping to pick you brains and see whether anyone has found a solution to this situation before.  We are moving house in a couple of months into my Husbands parents place.  Now, it's a mid terrace so there's no access from the back to the front without going through the house.  This however is only slightly relevant.

At the back of the house there is a set of French doors which are full glass.  This obviously poses a cat-flap problem.  Now, I know you can replace the whole glass panel with one that has a suitable hole cut in order to fit a flap however I presume this will be pricey.  We were wondering instead whether it's possible to replace one of the side panels (maybe half the width of a normal door) with a solid UPVC panel in order that we can make a hole in it to accommodate the flap.

Has anyone found anywhere that sells such a thing before or have any other solutions which might help?  I've been googling but didn't find anything of use.  We can't fit a flap with a wall tunnel as the walls are cavity filled and therefore not suitable for that.

TIA

LJ xx